WEND Lab R32 Skyline DIN Triple CANBUS Gauge - R32-3DIN

WEND Lab R32 Skyline DIN Triple CANBUS Gauge, part number R32-3DIN. Replaces the factory DIN triple meter in the Nissan Skyline R32.

• 3 fully configurable gauges that use the CANBUS data stream from an aftermarket ECU
• Made in the USA, case 3D-printed in temperature-resistant ASA plastic, purpose-designed electronics
• Customizable appearances and configurable warning levels
• Configured over Bluetooth with the iOS or Android app
• Auto-dimming displays with night mode
• Single DTM 4 pin connector wiring (a DTM-4 cable is required for installation)
• Direct replacement of the factory unit, uses the factory trim bezel
• Supported ECUs: Haltech (CAN protocol v2), Link (G-Series), Emtron (KV Series), AEM Infinity, MoTeC M1 Series (GPR/GPA/Powertune Australia FW), ECUMaster Black Series, MaxxECU, Syvecs (S-Series), MegaSquirt
• Supported gauges: battery voltage, water, oil, fuel and intake air temperature, exhaust gas temperature, water, oil, fuel and boost pressure, air fuel ratio, ethanol content, injector duty, throttle position, tire temperature and pressure, fuel tuning, engine health, boost control, gear position, speedometer, and 5 custom digital displays with 1-7 user-configurable parameters (the ECU needs the matching sensors and CAN configuration)

Fitment

• Nissan Skyline R32, factory DIN triple meter

Resources

• Installation instructions
• Warranty
• GaugeControl app (Android)
• GaugeControl app (iOS)

Contact us if you are unsure of fitment or Size HERE