GKTech V2 S13 bolt on angle kit (roll center correction kit, RCC kit), part number S13XRCK.
- Forged 1030 steel. Gives 1.57" (40mm) of roll center correction and 1.57" (40mm) of bump steer correction, and repositions the steering arm for more steering lock
- Two tie rod pickup points. The point furthest from the ball joint is the Grip position (40mm bump steer and roll center correction, a smaller increase in lock). The point closest to the ball joint is the Drift position (same corrections, faster steering, low Ackerman and the maximum lock)
- Bolts to the bottom of the standard knuckle and can be removed with no ramifications
- About 60+ degrees of lock is achievable without offset rack spacers once the factory LCA lock stop is removed. With lots of camber or caster, offset rack spacers help avoid steering bind
- Pushes the bottom of the wheel out 0.98" (25mm), which adds camber, so use with adjustable camber tops (without them expect about -3 degrees or more of camber). Camber tops are not essential
- Pushes the bottom of the ball joint out 30mm, which increases scrub radius by 30mm like a wheel spacer or lower offset rim. Clearance issues are possible with wheels below +20mm offset or wider than 10 inches
- A wheel alignment is required after installation (camber and toe change)
- Knuckle specific: cars running S14/S15 knuckles need the S14/S15 roll center correction kit instead
Fitment
- Nissan Silvia S13 (CA18)
- Nissan Silvia S13 (SR20)
- Nissan 180SX S13 (CA18)
- Nissan 180SX S13 (SR20)
Contact us if you are unsure of fitment or Size HERE