WEND Lab R33 Skyline GT-R DIN Triple CANBUS Gauge and Bezel Kit - R33-3DIN + R33-GTR-DIN-Bezel-1

WEND Lab R33 Skyline GT-R DIN Triple CANBUS Gauge and Bezel Kit, part numbers R33-3DIN and R33-GTR-DIN-Bezel-1. Replaces the factory DIN triple meter and bezel in the Nissan Skyline R33 GT-R.

What's in this kit

• 1 x WEND Lab R33 Skyline DIN Triple CANBUS Gauge, R33-3DIN
• 1 x WEND Lab R33 Skyline GT-R Triple DIN Bezel, R33-GTR-DIN-Bezel-1

• 3 fully configurable gauges that use the CANBUS data stream from an aftermarket ECU
• Made in the USA, case 3D-printed in temperature-resistant ASA plastic, purpose-designed electronics
• Customizable appearances and configurable warning levels
• Configured over Bluetooth with the iOS or Android app
• Auto-dimming displays with night mode
• Single DTM 4 pin connector wiring. A DTM-4 cable is required for installation and is sold separately
• Direct replacement of the factory unit
• The GT-R bezel replaces the OEM R33 Skyline GT-R triple meter bezel. 3D-printed in UV-resistant ASA plastic
• Supported ECUs: Haltech (CAN protocol v2), Link (G-Series), Emtron (KV Series), AEM Infinity, MoTeC M1 Series (GPR/GPA/Powertune Australia FW), ECUMaster Black Series, MaxxECU, Syvecs (S-Series), MegaSquirt
• Supported gauges: battery voltage, water, oil, fuel and intake air temperature, exhaust gas temperature, water, oil, fuel and boost pressure, air fuel ratio, ethanol content, injector duty, throttle position, tire temperature and pressure, fuel tuning, engine health, boost control, gear position, speedometer, and 5 custom digital displays with 1-7 user-configurable parameters (the ECU needs the matching sensors and CAN configuration)

Fitment

• Nissan Skyline GT-R (R33), BCNR33, factory DIN triple meter

Resources

• Installation instructions
• Warranty
• GaugeControl app (Android)
• GaugeControl app (iOS)

Contact us if you are unsure of fitment or Size HERE